7
8
Possible Cause/Solution
This is the low battery
signal. Replace
transmitter battery.
Check area for false
activation from heat or
reflective source. Re-aim
sensor if necessary.
1. Check area for false
activation from heat
or reflective source. Re-aim
sensor.
2. Receiver is in Manual
Override mode.
Flip wall switch off then on
again within 2 seconds to
place back in Auto Mode
1. Sensor is too far from
Receiver. move closer
2. Re-aim Sensor for
optimum motion
sensitivity. See diagram B.
Problem
• Light flashes on and off
twice when activated.
• Tone/Light activates for no
apparent reason
• Light Stays on at night
• Tone/light activates
irregularly when motion is
sensed
iTLTXDCB_Instructions.qxd 28/4/06 2:24 pm Page 8
