SECTION ONE
GENERAL INFORMATION
This floodlight features an integral daylight sensing photocell which will automatically switch the
light on at dusk and off at dawn or at a time set by the user.
Unit is for outdoor use only. Unit must be mounted as a fixed luminaire, and is not suitable for
portable use.
PARTS INCLUDED
- Low energy Floodlight c/w Dusk/Dawn sensor.
- Instruction manual. please keep safe for future reference.
- Accessory pack including screws and wall plugs.
- 4 pin low energy lamp.
TOOLS & PARTS NEEDED
- 3 flexible core cable (1.0mm² or 1.5mm²).
- electric/hand-held drill & bits.
- Terminal or electricians screwdriver.
- Wire cutters.
Do not attempt to install during wet weather, if you are suffering from nausea or dizzy spells or
on medication with similar side effects.
nO USeR SeRVICeABLe pARTS InSIDe.
SECTION TWO
INSTALLATION
After choosing a suitable location (see previous section) install the unit as follows:
The unit is suitable for connection to a 240 V ac 50Hz electricity supply. It is suggested that
3-core round flexible cable of 1mm² or 1.5mm² gauge is used. An internal switch should be
installed to switch the power to the unit On & OFF. This allows the unit to be easily switched off
when not required or for maintenance purposes.
This unit uses an integral wall fixing plate, detach the wall fixing plate by unscrewing the fixing
screw on the underside of the wall plate (diagram A).
The floodlight is located onto the wall plate by a lug which is inserted into the rectangular recess
in the top of the wall plate. To remove wall plate from floodlight, slide out the bottom edge and
lift upwards, the lug will lift out of the recess in the wall plate separate from the floodlight.
IT IS ReCOMMenDeD THAT THe LOW eneRGY BULB IS FITTeD AnD THe FROnT COVeR IS
SeCUReD BeFORe FITTInG THe FLOODLIGHT TO THe WALL
*** IMPORTANT ***
Switch off the electricity at the fuse box by removing the relevant fuse or switching
off the circuit breaker before proceeding with the installation.
