5
Stage
HOLD THEM FORWARD
ii)
iii)
i)
UN-TIE THE TWO MECHANISMS
3
Slat Frame Support Bar
3
During this next step, the assistant should hold up the
slat frame.
On side panels (3&4) slide gas-lift piston stems (X)
onto the axles (Y) then fit the flange lock-nuts (H).
Tighten nuts with spanner (E) -
BUT DO NOT
over-tighten. A small gap is left so stems can
move freely - this is important - see sketch below.
SMALL GAP
E
H
(X)
(Y)
3
H
Fitting Slat Frame - Use Pack 'B'
H
x2
E
x1
Page 6 of 8
