Page 7 of 8
7
Stage
8mm
Carefully lay frame down making sure there
is an even gap all round as in the sketch.
Hold frame securely then tighten all six
bolt sets 100% using spanner (E) &
Allen key (D).
Fitting Slat Frame - Use Pack 'B'
E
x1
D
x1
Stage
8
H
x2
E
x1
During this next step, the assistant should hold up the
slat frame.
On side panels (3&4) slide gas-lift piston stems (X)
onto the axles (Y) then fit the flange lock-nuts (H).
Tighten nuts with spanner (E) - BUT DO NOT
over-tighten. A small gap is left so stems can
move freely - this is important - see sketch below.
Note: Be very careful what
you store under the bed -
the top of an item, like a
suitcase or a box must not
touch the slats or they may
be
damaged. Maximum
storage height is 185mm.
SMALL GAP
E
H
(X)
(Y)
3
H