Cleaning:
• Do not use any chemical or abrasive cleaners.
• Clean product with only a soft dry cloth.
Warning:
• This product must be disconnected from the circuit if subjected to any high voltage or insulation resistance
testing. Irreparable damage will occur if this instruction is not followed.
Recycling Advice:
Waste Electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check
with your local authority or retailer for recycling advice.
Full Technical specification available upon request. Contact [email protected] for PDF.
Utility 40W Frame LED Light
Panel Non-Dimmable
Product Code
769119 | 769126
769133 | 769140
IP Rating
IP65
Beam Angle
120°
Lifespan
15,000 hours
Voltage
170-265V
Colour Temp
6000K-6500K Daylight
Energy Rating
A+
Warranty
2 Years
Instructions for new installations:
Ensure mains supply is switched off before installation.
1)
Provide power to the required point of installation.
This product has an angled bracket for ease of
installation and does not need to be removed.(Fig. 1)
2)
Using the angled brackets as a template, mark the
location of the fixing holes, and drill the holes
ensuring not to infringe with any gas/water pipes
or electrical cables.
3)
Remove the four screws on the access plate at the
rear of the fitting to expose the terminal block.
(Fig.2)
4)
Feed the cable through the copression gland on the
rear of the access plate. Ensuring correct polarity is
observed, carefully wire as shown in Fig.3.
5)
Replace the access plate, gasket and screws then tighten
the compression gland ensuring a tight seal to maintain
the IP rating. Switch on power supply and check for
correct operation.
