Timberwolf Entec TW 190H, Instruction Manual

Page: 12 / 41

OPERATING INSTRUCTIONS
10
AUTO CONTROLS
The no stress unit controls the feed rate of the material going into the chipping chamber. If the engine
speed is below the predetermined level the Speed Control Unit will not allow the feed rollers to work
in either forward or reverse until the rotor speed rises above the predetermined level, at which point
the feed rollers will start turning without warning.
There are two ways of stopping the TW 190H chipper in the event of an emergency.
STOPPING THE ROLLERS
Pushing the red button on the roller control box will stop the rollers immediately. This action will not
allow any further material to be fed in until it is reset. The button will stay in the 'pushed in' position.
To reset the button and continue working the button must be pulled out.
STOPPING THE ENGINE
Should the entire machine need to be stopped in an emergency the red button on top of the engine
cover can be activated. This will immediately stop the rollers and kill the fuel supply to the engine.
The engine will come to a halt in the shortest possible time. The engine cannot be restarted until the
button is pulled out.
EMERGENCY STOPPING
LOCATE the machine on firm level ground.
CHECK machine is well supported and
cannot move.
CHECK jack stand is lowered and secure.
CHECK all guards are fitted and secure.
CHECK the discharge unit is in place and
fastened securely.
CHECK discharge tube is pointing in a safe
direction.
CHECK the feed funnel to ensure no objects
are inside.
CHECK feed table is in up position - to
prevent people reaching rollers.
CHECK controls as described below.
CHECK (visually) for fluid leaks.
CHECK fuel and hydraulic oil levels.
For parts location see diagrams on pages 3 & 4.
DAILY CHECKS BEFORE STARTING
ENGINE CONTROLS
All the engine controls are located on the engine control panel (see
parts locator on page 4).
fig 6.
HOURS
COUNTER
POWER
ON / OFF
& START
POWER
ON LED
ENGINE
‘IDLE’
ENGINE
‘FAST’
INSERT key.Turn to heat.
HEATER LED comes on.
WAIT FOR HEATER LED TO GO OUT.
TURN
key to start position until it fires.
RELEASE key.
STARTING THE ENGINE
CONTROLLING ENGINE SPEED
The engine has two throttle settings, idle and fast. These are
controlled by the blue and green buttons on the engine control panel.
The
GREEN button will accelerate the engine to chipping speed.
The BLUE button will reduce the engine speed to idle.
1 4 6 2 9 7 5
HEATER
ON LED
0
1
2
If the engine fails to start after 10 seconds leave for 1 minute and try again.
OFF
ON
START
HEAT
1
2
0