Timberk TGH 4200 SM1, Instruction Manual, Page: 15 / 20

IM2020
15
loud click and see a spark on the piezo ignition electrode. Continue to hold the gas adjustment knob pressed
for 10-15 seconds from the moment the ignition torch ignites to activate the flame detector.
3. Leave the gas adjustment knob in this position for at least 5 minutes to permanently ignite the first heating
stage. The pilot (gas) burner and the central element of the ceramic burner will burn. This position
corresponds to a thermal power of 1.4 kW.
4. To change the heating level, slightly press the gas adjustment knob and smoothly turn it counterclockwise
until it locks in position
or , which will correspond to a heating thermal power of 2.8 kW and
4.2 kW.
5. Do not leave the gas adjustment knob in the intermediate position between the fixed positions,
,
and .
Turning off
1. Press the gas adjustment knob and turn it to the position, while the gas (pilot) burner and the
central element of the ceramic burner will burn.
2. Turn the valve on the gas cylinder clockwise until it stops, the gas burner (pilot) and the central element of
the ceramic burner should go out.
3. If you do not plan to use the heater in the near future, disconnect the gas cylinder from the gas reducer.
Take the gas cylinder to the storage place in accordance with the recommendations and requirements
described in this manual.
Gas cylinder replacement
1. Make sure the heater is turned off.
2. If you need to replace an empty gas cylinder, turn off the gas supply by turning the gas valve on the
cylinder fully clockwise.
3. Remove the cylinder lock and remove the cylinder from the heater body.
4. Remove the gas reducer from the cylinder by unscrewing the union nut of the reducer.
5. Connect and install a full gas cylinder as indicated in the “Installation” paragraph.
ATTENTION!
Do not smoke while replacing the cylinder.
Do not replace the cylinder if there is an open source of flame nearby.
Store gas cylinders in a separate, well-ventilated area, away from combustible materials. It is forbidden to
store and operate gas cylinders in apartments of multi-story buildings, basements, attics.
1. CLEANING AND MAINTANANCE
1. Regularly check the integrity of the gas hose between the gas pressure reducer and the gas valve of the
device. If damage to the hose is detected, the device must not be operated, hose must be replaced.
2. Regularly check all gas connections, tubes and devices for gas leaks (using soapy water). If a gas leak is
detected, immediately stop operating the heater, disconnect the gas cylinder and contact the dealer or an
authorized service center.
3. The device must be washed regularly to remove dust and dirt from external surfaces, as this affects the
efficiency of its work and the temperature parameters of heating the room. Before carrying out maintenance
work, turn off the appliance, let it cool, then wipe its surface with a soft, slightly damp cloth.
4. It is not recommended to use detergents for washing, including abrasive products. Do not damage the
device with sharp objects, as scratches on the painted surface can lead to rust.
5. The back surface of the gas heater must also be periodically cleaned of dust and dirt. The preventive
cleaning procedure should be carried out periodically to maintain the technical condition of the heater and
preserve its appearance for many years.