Timberk TAP FL700 MF BL, Instruction Manual

Page: 5 / 24

F) Cleaning indicator
If red «CLEAN CELL» indicator appears on the display, the appliance should
be cleaned as recommended by the manufacturer. When the collector cell
is re-installed after cleaning, switch on the appliance and keep pressing
the button « » at least 3 seconds until buzzer beeps, red «CLEAN CELL»
indicator goes out and «CLEAN CELL» timer is reset.
G) Catalyst indicator
H) Replace indicator
If red «REPLACE FILTER» indicator appears on the display, the VOC/
Formaldehyde filter should be replaced as recommended be the
manufacturer. When the VOC/Formaldehyde filter is reins – talled after
replacement, switch on the appliance and keep pressing the button « » at
least 3 seconds until buzzer beeps, red «REPLACE FILTER» indicator goes
out and «REPLACE FILTER» timer is reset.
I) Fan speed indicator
J) Timer indicator
7. CLEANING AND MAINTENANCE INSTRUMENT
Cleaning the Collector Cell
1. Unplug the appliance.
2. Open the front cover by gently pulling from the top comers.
3. Remove the collector cell by unlocking top and bottom knobs and
pulling straight out.
4. Separate the collector cell from the wire assembly for easier access to
each during cleaning.
5. Place each in sink, bathtub or other location where
cleaner can cover every surface.
6. Spray specialized cleaner between each cell plate and cover each
surface. Allow the cleaner to soak for a few minutes but do not let it dry.
Thoroughly rinse the collector cell with clean water.
An alternative method to clean the collector cell is
to rinse or soak it in warm water for loose debris. Mild liquid dish detergent
in water may also be used to help break down tough dirt and residue.
Thoroughly rinse the collector cell with clean water.
7. Place the collector cell under the sunlight to dry at
least 3 hours. Shake excess water from the collector cell to speed up
drying time. Do not use heated or compressed air to dry.
8. Reassemble the wire assembly and collector cell by inserting the post
located on the outside edges of the wire assembly into the recessed
channels of the collector cell. After guiding the post into the recessed
channels, slide the wire assembly until it locks into place.
9. Place the collector cell back into the unit by sliding it straight in and
turning each knob to its locking position. The collector cell is specially
designed so that it can only be inserted in one direction.
10. Close the front cover securely.
ATTENTIONS!
• The collector cell may not require if «arcing» occurs.
Arcing is a snapping sound that occurs when large
particles are collected in the collector cell or the
appliance used in over-damp rooms.
• If prolonged or continuous arcing occurs, the collector
cell should be cleaned.
• To prevent damage to the components of the collector
cell, do not put in dishwasher or use a cotton swab.
• Tough residue such as tar from tobacco smoke may
need additional cleaning or longer soaking.
• The collector cell must be completely dry after cleaning
in order to operate properly. If the power supply detects
the collector cell is wet, it shuts down power to the cell
and cause the red «CLEAN CELL» indicator to blink
rapidly. Please re-dry the collector cell until the power
supply successfully restarts, the appliance will return to
its original speed and run as normal.
Cleaning the Pre-Filter
1.Unplug the appliance.
2.Open the front cover by gently pulling from the top corners.
3.Pull the pre-filter straight out of the cabinet.
www.timberk.com • air purifier
5