Timberk SWH
RE3
100
V, Instruction Manual

Page: 6 / 28

6
6. WATER HEATER INSTALLATION
Location
1. Electric water heater should be mounted on a firm wall.
2. The wall, where the electric water heater is to be mounted, must
withstand at least the double weight of the water heater, fully filled with
water; there must be no cracks and other damages on the wall. Otherwise
it is necessary to take measures to strengthen the mounting or mount the
water heater on a special support.
3. If a bathroom is too small, the water heater can be installed elsewhere,
unexposed to direct sunlight and unavailable for moisture. However, to
reduce heat losses in pipelines, the location, where a water heater is to be
installed, must be as close to the place, where hot water is used, as
possible.
Fig. 6
Water heater mounting methods
Fig. 6 shows the way to mount the water heater for one consumption
point ( for SWH RE3 ... V).
1. Power cord with a plug
2. Magnesium anode water discharge nozzle
3. Water outlet
4. Hot water supply adjustment tap*
5. Mixer*
6. Shower header*
7. Cold water supply adjustment tap*
8. Pressure relieving opening
9. Check relief valve
10. Water inlet
11. Water heater
12. Water main shut-off valve*
13. Water main
14. T-bend*
Water heater mounting methods
Fig. 7 shows the way to mount the water heater for several
consumption points (for SWH RE3 ... V).
Fig. 7
* Does not included in the scope of delivery
10
9
8
7
11
12
6
1 3
5
4
3
2
Vertical installation
Vertical installation
IMPORTANT !
You can use the same way of installation for SWH RE4 ... VH series.
But, please, note that pipe of cold water (9) is on the left position.
Pipe of hot water (2) is on the right.
www.timberk.com e lectric storage water heater