www.timberk.com • electrical storage water heater
8
Fig. 6
1 – power cord with a plug and GFCI**
2 – mounted water heater
3 – composite pressure safety valve
4 – cold water inlet tap*
5 – mixer*
6 – shower header*
7 – water main shut-off valve
8 – discharge pipe
9 – water main
10 – tub*
11 – T-bend
1. Electric water heater should be mounted on a firm wall. If the wall is not
robust enough to hold the weight equal to the doubled weight of the overall
water heater weight, fully filled with water, then it should be mounted on a
special support.
2. After you chose the proper place to install the water heater, determine
points for holes for expansion hook bolts (to be determined in accordance
with the data sheet for the appliance you chose). Drill two holes of the
corresponding depth in the wall using a drill, dimensionally fit for expansion
bolts, enclosed with the water heater, insert bolts, turn the hook upwards,
securely tighten nuts and then hang the electric water heater on these
hooks (for RS1/RS2 series) (see Fig. 7).
3. Fix a power outlet to the wall. Requirements to the outlet are as follows:
230~V/10A, single-phase, three-wired. It is recommended to place the
outlet on the right side above the water heater.
NOTE:
Please, use accessories, provided by the
manufacturer, to install the water heater. Electric
water heater must not be mounted on a wall prior
you make sure that the bracket is installed firmly and
securely. Otherwise the electric water heater may fall
down from the wall, which may cause its damage and
even serious accidents involving bodily injury. When
determining points for bolt holes, it is necessary to
provision some spare space between the lower part
of the water heater and the floor, and as to the RS2
line there also must be some space between the right
side of the water heater and the wall on the right,
not less than 0.6 m to make it convenient to perform
maintenance if necessary.
Water heater mounting methods
Fig. 6 shows the way to mount the water heater for several consumption
points.
12 – magnesium anode-nozzle for water discharge (for RS2 series)
* not included in the scope of delivery
** depending on the product batch, GFCI can be located not within the power cable electric plug
Water heater mounting
