IM2020
27
9. OPERATION OF THE DEVICE
THC WS2 2.5M AERO control knob
Fig. 6*
1. Operating mode selector knob
It is used to turn on/off the curtain and select the following operating modes: ventilation mode
, low heating power mode
, high heating power mode
.
*The appearance of the control panel may differ from the images in the manual
THC WS2 2.5M AERO operation
1. Turning on
1.1. Before switching on the air curtain, the operating mode selector knob must be set to
.
1.2. Connect the air curtain to the power source by plugging the power cord into a power outlet.
1.3. Set the operating mode selector knob to the
position, and the device will begin
operation in ventilation mode.
ATTENTION!
After transportation or storage of the air curtain at below 0
0
C temperatures, it is necessary to
store it in the room where operation is supposed to be, without turning the device on for at least
2 hours. After prolonged storage or break in use, do not turn on the curtain in high heating power
mode.
2. Heating power mode selection
2.1. To select a low heating power, set the mode selector knob to
.
2.2. To select a high heating power, set the mode selector knob to
.
ATTENTION!
The first time the curtain is turned on, a specific odor and smoke may appear (oil is burned from
the surface of the heating elements). It is recommended to turn on the curtain in heating mode
for 10-20 minutes in a well-ventilated area before installation.
3. Overheat protection
To ensure safe operation, the curtain is equipped with a thermal limiter that turns off the heating
elements in case of overheating. Overheating can be caused by:
- perforated air inlet grille or air outlet grille are closed by foreign objects or they are dirty;
- faulty fans.
Summary of Contents for AERO I Series
Page 36: ...36 www timberk ru ...
