ASSEMBLY AND WARNINGS
ABOUT THE GRINDING WHEEL
There are two types of grinding wheels, 1 / 8 "and 3 / 16" for sharpening chains from 1/4” to 3/8”pitch.
To replace or change grinding wheels:
Always disconnect from any power source
Remove blade protective shield, by removing screw at top of shield then pulling upward (straight up).
You may need
to pull hard to remove.
See FIGURE#3 below for properly securing grinding wheels with plastic nut.
Be sure plastic secure nut is assembled
in correct direction as per figure 3.
ALWAYS CHECK GRINDING WHEEL FOR ANY DAMAGE BEFORE USE
START-UP
FIRST:
Check that you have proper size grinding wheel to match your chain.
Check your chainsaw CHAIN mfg specifications for proper wheel size, and/or refer to chart below.
Be sure the wheel is securely installed and ALWAYS check wheel for any damage BEFORE EACH USE.
NEVER use without wheel guard installed.
NEXT:
Install the sharpener onto chainsaw chain bar, approximately centered.
-
Notes:
Always hit the STOP/RED off switch to stop the grinder. The provided power cables are complete with
terminals for quick and safe connection to any 12volt battery (SEE fig. 5). This allows the operator to use this sharpener
on-the-job or in-the-field, wherever a 12volt battery is available.
