1
2
3
4
19mm Rod
Compatibility
15mm Rod
Compatibility
Slide the Motor into position under the lens gear.
Bushing allows for 19mm to 15mm compatibility
1. Loosen knob on Rod Adapter
2. Adjust the position of the Motor
3. Embrace the Motor Gear with the Lens
Gear snuggly
4. Tighten the knob on Rod
Adaptor
08
Nucleus-M: Shoulder Mount Assembly
Inserting the Batteries
Attaching the Motor to a DSLR Camera
Note:
If the lens already has a 0.8 gear or has been modied to have one, then the motor
can be attached and calibration can begin just as if it were a cine lens
Add the follow focus ring to the lens. Secure it tightly. Make sure the fastener is not
in a position where the motor's gear will hit it during it's calibration run.
Once the follow focus ring is on the lens, follow the same steps for calibration as if
it were a cine lens
07
Hold the Handle. Push the
【
Open
】
.
The battery compartment latch will release.
Place (2) 18650 Batteries in any direction -
as long as positive and negative ends on
the batteries touch - and then close the latch
Installing the Batteries in the FIZ
Hold the FIZ Unit. Push the
【
Open
】
.
The battery compartment latch will release.
Place (2) 18650 Batteries in any direction
and then close the latch
Installing the Batteries in the Handles
+
-
+
-
