TECHNISONIC INDUSTRIES LIMITED
www.til.ca
TDFM-7300-2 Installation & Operating Instructions
TiL 10RE430A
2-11
Squelch Blink -
When disabled, the squelch indicator lights will function normally. When
enabled, the squelch lights will stay lit while a signal is present and then
blink for a couple of seconds after the signal disappears. This can help
to determine which band made the last call.
Boot Speed -
When set to quick, some boot up messages will be skipped. When set
to normal, all messages will be displayed.
Panel Lighting –
Select 28 volts DC or 5 volts AC. No damage will occur if the wrong
setting is made.
F1-F4 Keys –
If set to normal, the keys will emulate the side buttons on the portable.
If set to channels, the keys become quick channel load keys. The
channels can be programmed in the second function menu.
Sidetone 1 Level –
Sets the sidetone level for band 1. The microphone and headphone
audio becomes live while in this mode to facilitate setting to a
comfortable level
Sidetone 2 Level –
Sets the sidetone level for band 2
Sidetone 3 Level –
Sets the sidetone level for band 3
Sidetone 4 Level –
Sets the sidetone level for band 4
Sidetone 5 Level –
Sets the sidetone level for band 5
Press the knob to accept the setting. The radio will then power up normally. The radio will keep
these settings until they are changed again by the configuration menu.
2.18 KEYLOADING
MODE
If the TDFM-7300-2 is equipped with hardware encryption, then the Encryption keys will need to
be loaded using a Motorola KVL 3000+® Keyloader.
Keyloading must be done by putting the transceiver into flash upgrade mode by turning on the
radio while holding the HOME key. Select the band to be keyed-loaded by pressing the BAND
key. Press the RESET Key to reset the modules and to put them into keyload mode. Wait until
the display returns to the “Flash Upgrade mode” Power up the keyloader and plug the cable into
the 7300-2 Program port. Follow the Motorola Keyloader instructions for uploading the actual
keys to the radio.
If other bands require keys, press the BAND key to select the next module, wait 1 second for the
module to sense the keyloader, then upload the key(s).
When keyloading is done, remove the keyloader cable and press the EXIT key to reboot the
transceiver back to normal operation
