IP Phone 202 User Manual
Phone Features Settings
Options
Meaning
Early Dial
Default is “No”. Use only if proxy supports 484 response
Dial Plan Prefix
Sets the prefix added to each dialed number
No Key Entry
Timeout
Default is 4 seconds. This is the time lapse after entering a phone number for the IPPH
202 to begin completing your call.
Use # as Dial Key
This parameter allows users to configure the “#” key to be used as the “Send / Enter” (or
“Dial”) key. If set to “Yes”, pressing this key will immediately trigger the sending of
dialed numbers entered thus far. In this case, this key is essentially equivalent to the
“(Re)Dial” key. If set to “No”, this “#” key will then be included as part of the dial
string to be sent out.
Auto Answer Voice
Default is NO. When set to yes the phone will automatically pick up
the call and turn the speaker on.
Voice Mail UserID
This parameter defines the User ID (or extension number) of a 3rd
party voice mail system where the user may have an account. By
defining this Voice Mail extension, when the user presses the
“Message” button on the phone, an INVITE message will be sent to
that extension to allow the user to retrieve messages.
Off-hook Auto-Dial
This parameter allows users to configure a User ID or extension number to be
automatically dialed upon off-hook. Please note that only the user part of a SIP
address needs to be entered here. The IPPH 202 will automatically
append the “@” and the host portion of the corresponding SIP address.
Enable Call Features
Default is “No”. If set to “Yes”, Call Forwarding & Do-Not-Disturb are supported
locally
Disable Call Waiting Default is “No”.
Default Ring Tone
The user can setup up one number on each of the ring tones 1, 2 and 3. When a call is
received from one of these numbers, the respective ring tone will be generated.
Other Settings:
Copyright © 2003 Tiger NetCom Corporation
Page 13 of 21
