Tiger SIDE FLAIL, Mounting And Operating Instructions

Page: 48 / 204

ASSEMBLY
Assembly Section 2-22
LIMIT SWITCH MOUNTING
ASSEMBLING LIMIT SWITCH
Mount bracket 1-5/8” down from top edge on the
inside of the rear arm of the draft beam, (Fig. A) square
with inside corner as shown with the square corners
against arm. Weld plate no more than 5/8” x 1/4” on top
as shown.
Assemble limit switch with wheel on body side of
arm and with the rear of arm mount aligned with fourth
notch on arm as shown in Fig. C. Fasten limit switch cam
to bonnet with the 7/16” x 3-1/2” pin bolt and flatwasher
as shown in Fig. D.
ADJUSTING LIMIT SWITCH
To adjust switch do as follows:
1. With cam in place and pin bolt installed, raise mower
to desired shutoff angle.
2. With pin bolt loosened turn cam until roller follower just
reaches peak (see Figure E) and tighten pin bolt.
3. With switch arm mount screw (see Figure C) loose turn
shaft (see Fig. E) with screwdriver in direction of
follower rise while holding follower against cam peak
until switch clicks off and hold while tightening arm
mount screw.
WIRING LIMIT SWITCH
Remove top cover on switch to expose terminals.
Connect red wire to either of the back terminals, and the
black wire to the other back terminal. Cut the white wire
to solenoid valve at a place closest to the tilt-angle switch.
Connect the red wire to one of the cut ends and the black
wire to the other end. This connects the switch in series
with the solenoid valve.
(ASM-C-0028)