Tiger JD6175R, Mounting And Operating Instructions

Page: 48 / 236

ASSEMBLY
Assembly Section 2-18
TEMPERATURE GAUGE MOUNTING
(OPTIONAL)
Mount the temperature gauge where it is clearly visible to the operator. Attach the green (-)
wire from the negative post on the gauge to a grounded bolt on the tractor frame. Remove paint
if needed to make a good ground. Remove the pipe plug from the side of the hydraulic reservoir
and install the temperature sensor using thread sealing tape. Run the white wire from the (s)
sensor post of the gauge to the temperature sensor on the hydraulic reservoir tank.
(ASM-C-0051)
WHEEL WEIGHT MOUNTING
For all tractors using a boom mower, a wheel weight will be required for the rear left side
wheel. It will be necessary to mount the weight in the wheel using the long capscrews,
lockwashers, flatwashers, spacers (if applicable), and hex nuts per the diagram in the Parts
Section.
Installation is most easily done with a fork lift, inserting a fork in the center slot of the wheel
weight. The head of the capscrews is to be toward the OUTSIDE of the weight, with flatwashers
on both the inside and outside of the assembly.
The left rear tire may also be filled with a mixture of water and calcium chloride at about five
pounds per gallon. Tire air pressure should be maintained according to the Maintenance
Section.
(ASM-C-0055)