Tiger JD5075E T4F, Mounting And Operating Instructions

Page: 32 / 202

ASSEMBLY
Assembly Section 2-2
Before attempting to mount your Tiger mower, it is important
to read and understand all of the safety messages in the Safety
Section of this manual.
Check complete shipment list against the packing list to make sure there are no
shortages. Make certain the tractor model is the appropriate one for the mower received!
Always use a floor jack, hoist or fork lift to lift and raise heavy parts.
Read and understand the entire Assembly Section instructions before attempting to mount
your Tiger mower. Refer to the Parts Section of this manual for detailed illustrations to locate all
parts.
(ASM-C-0001)
TRACTOR PREPARATION
A. Remove engine side panels, or raise hood to access front pulley.
B. Remove plugs from tractor casting where mainframe and pump mount will be attached.
C. Remove any front weights and weight supports.
D. Raise the tractor onto jack-stands and remove the right and left rear wheels.
E. Remove exhaust and mount, discard the mount. The hardware that connected the
exhaust to the mount will be re-used.
(ASM-JD-0001 5075E)
TRACTOR MODIFICATION FOR DRIVESHAFT
It may be necessary to drill a hole in the tractor’s front bolster to provide access for the drive-
shaft. See Parts Section for more information on driveshaft and front pump.
(ASM-JD-0060 JD5075E)