Tiffin Motorhomes 2014 Allegro Bus, Owner'S Manual

Page: 62 / 151

TIFFIN MOTORHOMES –ALLEGRO BUS® Chapter 7 ELECTRICAL FEATURES
If the batteries are not going to be used for an extended period of time, they should be removed from the Allegro
Bus and stored in a warm, dry place. IT IS STRONGLY RECOMMENDED that this service be performed by a qualified
service technician, as the process is usually too complicated for the average owner to perform.
For those who may wish to perform this service themselves, the following
procedure is described: Mark the battery cables (“+” [plus] sign or “red”
for the positive cable; “-” [minus] sign or “black” for the negative cable) so
that they can be properly reconnected again later. Then disconnect the
negative terminal(s) from the batteries. Afterwards, disconnect the positive
terminals. Now the batteries can be removed for storage. When the
batteries are moved, keep them upright at all times. To reinstall the
batteries at a later date, reverse the above-described process. While in
storage, these batteries would require periodic recharging to maintain
their full charge.
Additionally, the batteries will, over time, lose some of the water used with
the sulfuric acid in the batteries. Following manufacturer’s
recommendations as found in the Owner’s Information Package,
periodically check the fluid levels in all the cells of the batteries (be sure to
use safety eyewear during this process) and fill those that are low with
water (distilled or de-ionized water is preferred; tap water is also
acceptable).
Don’t overfill the cells; follow the filling directions exactly. This battery checkup
should be done on a regular basis to realize the fullest service possible from the
batteries over the longest time possible.
The batteries are installed on a sliding tray (Figure 7-6) which allows you to extend
out of the compartment to check battery and water levels. Located inside the
compartment is a handle (Figure 7-7) that must be pulled in order
to release the slide tray.
NOTE: Your Allegro Bus may be equipped with maintenance free glass matte batteries. If so, these batteries WILL
NOT be installed on a sliding tray.
If the Allegro Bus is to be stored for an extended period of time, the 12 VDC battery system should be
disconnected—this will prevent unnecessary drain and corrosion of the batteries and their terminals.
7-6
Figure 7-6. Battery Slide Tray
Figure 7-6.
Release Handle for Slide Tray