19
MASTER PROGRAMMING
Familiarize with Button
Configuration:
CALENDAR
CLOCK
TIME
10:15 AM
REMAIN
DAYS 03
TIME
10:15 AM
REMAIN
GAL 1075
TIME
10:15 AM
REMAIN
GAL 1075
TIME
10:15 AM
REMAIN
DAYS 03
REMAIN
GAL 1075
METER
IMMEDIATE
METER
DELAYED
METER
OVERRIDE
PROGRAM LEVEL
USER ACCESS
MASTER (III)
These settings are programmed by the factory. The settings are important for the operation of the valve that should
only be changed by a qualified person.
FACTORY (II)
These settings are programmed by the factory and should be adjusted when the valve is assembled into a unit or
system. It contains important settings so the valve will operate properly for the type of system it is intended for. The
settings should only be changed by qualified person.
USER SETTINGS(I)
These settings are programmed when the unit is installed. The settings should only be adjusted by a qualified person.
This function is to accept the values if changed and advance to the next page in
the menu.
These buttons are used to increase or decrease the value of the settings while in
the programming mode.
This function is to enter the basic set up information required at the time of
installation.
Key Pad Configuration:
PROGRAMMING LEVELS
There are 3 levels to the valve program. Master options and Factory options are typically adjusted at the factory. These options link the PCB function with the type of control
valve and should not be tampered with. Advanced options are used to configure the unit when the valve is assembled to the tank so that it can function as the proper size and
intended system operation. Settings are the final options chosen when the unit is installed to a specific location.
MAIN DISPLAY OPTIONS
The main display page according to the regeneration mode setting. The display will alternate between the time of day, remaining gallons, and remaining days..
