17
RES-UP FEEDER INSTALLATION
5/8" hole in brine
well cap
Res-up feeder
1/4” Holes
Res-up Feeder Bottle (Chemical sold Separately)
The 12 cc feeder is for conditioners up to 64,000 grains (2 ft3 of resin).
The 30 cc feeder is for larger conditioners over 64,000 grains.
Pro-Res Care Chemicals
RK41N
Pro-ResCare - Gallon
RK32N
Pro-ResCare - Quart
1.
Install the grid and brine well inside the tank.
3.
Mark the location of the holder and drill.
2.
Measure 2 inches from the top of the tank beside
the oblong molding.
Install Resup Feeder - Round Brine Tank
Care of Your Softener
To retain the attractive appearance of your new water softener, clean occasionally with a mild soap solution. Do not use abrasive cleaners, ammonia or solvents. Never
subject your softener to freezing or to temperatures above 4
0
°C (1
00
°F).
Servicing Components
The injector assembly should be cleaned or replaced every year depending on the inlet water quality and water usage.
The seals and spacer cartridge should be inspected/cleaned or replaced every year depending on the inlet water quality and water usage.
See pg. 17 for instructions.
Not following the above will void all warranty on the control valve.
Resin Cleaner
An approved resin cleaner MUST be used on a regular basis if your water supply contains iron. The amount of resin cleaner and frequency of use is determined by the quantity
of iron in your water (consult your local representative or follow thedirections on the resin cleaner package).
Res-Up Feeders attach to your brine tank and automatically dispense the Res-Up cleaner into the brine solution where
it cleans the resin during the regeneration cycle.
The feeder hooks onto the tube inside your brine tank and you just pour some chemical in it and your water softener
should last significanly longer. A res-up feeder is essential if your raw water contains measurable amounts of iron.
20
4.
IInstall the holder and the Res Care Solution
5.
Take off the small hole cover on the Brine
Well lid.
6.
Take off the cover of the Res care bottle . Insert the
wick, making sure it touches the bottom of the
bottle. Insert the other end of the tube completely
into the hole in the brine well cap. Automatic
feeding will start in a few hours.
1.
Install the grid and brine well inside the square tank.
3.
Mark the location of the holder and drill.
2.
Measure 2 inches from the top of the tank beside
the oblong molding.
