5
Timer function (base setting):
If your trolley is fitted with dual button control, press both buttons;
if it is fitted with a twist-grip control, press the single button while
the trolley is parked. Press both buttons/the single button until
the LED lights up. Your trolley will now drive about 10 metres and
then come to a stop. Press both buttons/the single button until
the LED starts flashing. Your trolley will now drive about 20 me-
tres and then come to a stop. You can stop the timer function at
any time by pressing both buttons/the single button. The relevant
timer setting will be confirmed by the LED.
10 metres - LED lights up
20 metres - LED flashes
Memory function
If you do not want to use the handle to bring the trolley to a stop,
you can also use the single button (3). Pressing the single button
(3) again will make the trolley start up again at the speed that was
used last.
Releasing and applying the electromagnetic parking brake
If you have stopped your trolley by pressing the single button
(3), you can release the brake by twisting the handle right back
to zero. The brake can be reactivated by pressing the single but-
ton (3) again. To start the trolley up again, twist the handle to the
right.
If you have stopped your trolley by twisting the handle until it
reached zero, you can release the brake by pressing the single
button (3). The brake can be reactivated by pressing the single
button (3) again. To start the trolley up again, twist the handle to
the right.
Changing the timer function (only for trolleys with dual button
control):
To change the timer‘s manufacture settings, proceed as follows:
Disconnect the battery connector from the trolley and wait 30
seconds.
Depending on the required timer function, press the following
button(s):
» from a standing position –
both buttons
» from a standing position and while driving
–
“Faster” button
» without timer function (e.g. if using the remote control)
–
“Slower” button
Connect the battery connector to the trolley while the button(s)
is/are being pressed down. The LED will now show the previous
timer setting after approx. 3 seconds. After another 30 seconds,
the LED will start indicating the new timer function.
» from a standing position –
LED lights up continuously
» from a standing position and while driving
–
LED flashes fast
» without timer function (e.g. if using the remote control)
–
LED flashes slowly
You can now release the button(s) and the new timer function will
be applied.
Operating the timer while driving the trolley:
To activate the 10-metre timer function while driving the trolley,
press the “Slower” button twice (double-click), after which the
LED with light up.
To activate the 20-metre timer function, press the “Faster” button
twice, after which the LED will flash.
