18
SME70, SME70-C, SME70-M-Manual-04-2020
C O M M I S S I O N I N G
ATTENTION - CLOSE JUMPER X21 and JUMPER X22
For start up, apply the auxiliary power voltage fitting the connector in the remote control outlet.
Upon start up, all of the eight leds are controlled to light up for a short time; afterwards, they turn off
except for led ON and V4, V8, V12, if voltage on the corresponding phases is ON.
The settings must be made by Personal Computer with sw Thyvisor
THYVISOR
The Thyvisor sw is a “browser” of data (setting, measure, etc..); it implements an engine that is
afford to rebuild the menu set up and the relationships to data concerning all Thytronic protective
relays by means of XML files.
Following operations are performed by means Thyvisor:
• Open-store of setting files;
• Create network of relays
• Configuration of communication based on protocol IEC 61850
• ASCII or Excel export reports;
• Open/close communication;
• Send settings, read settings;
• Firmware upgrades;
• Session level selection and log enabling (log files);
After the device selection Thyvisor allows to:
• Set the relay reference data;
• Read info, measures, etc... ;
• Store settings.
—
Thyvisor installation
The latest release of ThySetter can be downloaded free of charge from the
www.thytronic.it
site
(Products / Software / Thyvisor - DOWNLOAD AREA).
Setup
Once the release you want to install is available, just run both files (ie: ThyVisorSetup_V1.4.8.33.exe
and ThytronicTemplates_V1211_IT_US.exe).
If an older version is already present, a suitable message will ask user to remove the oldest before
proceeding.
This chapter is a short description of the main commands of Thyvisor software.
