ThyssenKrupp Access Citia BOS, Installation And Service Manual

Page: 11 / 22

11
F. INSTALL THE CHASSIS ASSEMBLY INTO THE
TRACK
NOTE: If you will need to change remote frequencies
on the call/send remote controls do this PRIOR
to mounting the chassis on the track. With the
chassis close to the wall, it may become diffi cult
to remove the shroud and access the control
board. Refer to Step C of the Service Information
for instructions on changing the frequency of the
remote control.
Attach the track mounting brackets to the staircase.
The brackets attach to the stair treads with wood
screws.
The bottom of the track should be touching the
nose of stairs once the brackets are bolted down.
Cut open the stair lift box, pull out the unit
which will be attached to a plank of wood.
Use the plank to support the unit, and
carefully transport the unit to the top of the
staircase.
Do not carry the unit by the plastic shroud!
Doing so could cause the unit to come away
from the shroud and cause serious injury!
Stair lift Chassis Stair lift Chassis
Wooden Mounting Plank Wooden Mounting Plank
Mounting Plates Mounting Plates
Load Tool Load Tool
Unbolt the mounting plates to free the stair
lift unit and load tool. There will be two bars
protruding from one end.
Track Bracket installed.
Track Bracket cover installed.