11
PREPARATION AND ASSEMBLY
1. After unpacking the product, inspect carefully for any damage that may have
occurred during transit. Make sure to tighten fittings, bolts, etc., before put-
ting unit into service. Tighten the gun to the cup securely using the connector
with filter inside.
2. Thoroughly mix and thin paint in accordance with the paint manufacturer’s
instructions. Most materials will spray readily if thinned properly.
3. Strain material through filter, cheese cloth or a paint strainer.
4. Tighten the gun to the cup securely using the connector with filter inside.
5. Fill the cup about 3/4 full and start the air compressor.
6. After connecting the gun to air supply, make sure that the Cup Cover, Cup
and Air Hose have been connected tightly with spray gun.
7. Set up a piece
of cardboard or
other scrap ma-
terial to use as a
target and adjust
for best spray
pattern.
CUP
CUP COVER
AIR
INLET
AIR HOSE
COMPRESSED
AIR
OIL AND
WATER
EXTRACTOR
To Air
Compressor
DO NOT EXCEED Maximum Pressure of Spray Gun
or any other parts in the compressor system.
Maximum pressure is 70 PSI.
Consult with the paint
manufacturer for recommended air pressure.
Some Regulatory Agencies prohibit the operation of HVLP spray guns
above 10 PSI nozzle atomizing pressure.
Summary of Contents for H827C
Page 2: ...2...
