5
19. Locate two vertical fins. Apply decals on the fin.
Note: Start from leading edge to apply the decal.
20. Note the orientation vertical fin. Photo shown is
right fin.
21. Make marks on the vertical fin then trim away the
excess portion.
22. Epoxy the ver tical fin in place as shown. To
reinforce the fins in place, you may need to cut a
5/8"(1.5cm ) in width and 3"(7cm) in length of a
transparent strips then tape the fin at wing tips
through the hole on the vertical fin.
23. Connect all wires to receiver then place ESC,
Battery and Receiver as shown.
24. Locate the drive shaft then secure the drive shaft
on motor with the furnished setscrew and hex
wrench. Next secure the propeller with the prop
nut. Note: the drive shaft and prop nut are in
opposite thread. Thread the prop nut counter
clock -wise.
25. Route the antenna through the tube as shown.
Congratulations! You are most ready to fly. Make sure
fine tune the plane before you fly.
ASSEMBLY / VERTICAL FINS