with deck installed. Make sure the deck is free
and it could be removed from fuselage.
16. Locate Velcro and cut it into two pieces. Attach
Velcro on the two sides of fuselage.
17. Install the deck and carefully set the deck in place
then glue the Velcro.
Hint: Bend the deck and glue one side first then the
other.
18. Epoxy the wood skid and antenna tube at the
bottom fuselage as shown.
4
12. Next glue the part A and B to complete whole
motor mount. Secure motor with M2.6x8 screws
and washers.
13. Epoxy the motor mount assembly at the tail. Make
sure the motor mount is all the way in the fuselage
and secured firmly after it is cured.
14. Trim deck, canopy and nose cone along with the
molded line as well as the cooling slots at the tail
of deck. You need to trim the canopy tabs and
deck to get a good fit when canopy is installed on
the deck.
15. Glue nose cone in place
ASSEMBLY / MOTOR, CANOPY