15
ENGINE MOUNT & FUEL TANK
❐
Attach the engine mounts to the firewall using the socket head bolts
and blind nuts.
❐
Set the engine on the engine mounts and measure from the firewall
to the front of the thrust washer 6 1/4". Now use a marker to mark the
engine mounting holes on the engine mounts.
❐
Use a marker to mark the engine mounts as right and left.
Now remove the engine mounts. Place into a vise and drill and tap the
holes using an 6/32 or M4 x 0.7 Tap.
❐
Mark and drill the hole for the throttle pushrod tube. Install the
pushrod tube and use a couple of drops of medium CA to hold in place
in the firewall. Now install the throttle pushrod, attaching Z-bend end
to the throttle arm. You may now permanently install the engine by
using the enclosed 6/32 x 20mm or 4 x 20mm socket head screws.
We advise that you use a couple of drops of blue Loctite™ on each
motor mount bolt.
VIII. Fuel Tank
❐
Assemble the fuel tank.
❐
Install the fuel tank, then install the throttle servo tray using
medium CA. This tray holds the fuel tank into place, so place it as far
