WING
1.Carefully and slowly insert the main wing into the
fuselage then center it in place.
2. Glue the CFK rods on Aileron, Rudder and Elevator
as indicated.
3. Install and center the horizontal tail in place, make
sure the horizontal tail is perpendicular to the vertical
fin and parallel with the main wing. Next CA the main
wing and horizontal tail firmly in place.
4. Install four CA hinges on the aileron as shown,
carefully use the sharp hobby knife to cut the slots on
aileron and trailing edge of wing for the hinges.
5. Attach the aileron to the trailing edge of main wing
then apply CA glue to all hinges and make sure
they are jointed well. Do the same procedure on
the other aileron.
6. Install four CA hinges on the rudder, use the same
way as you did on aileron. Next glue the rudder on
the vertical fin.
4
TAIL
7. Glue the FRP control horn and elevator reinforced
plates together as shown. Make sure the two
rein forced pieces are glued properly at each side of
elevator so the control horn could be installed
perpendicularly at left.
8. Do the same procedure as elevator control horn
to install the rudder control horn as shown at right.
9. Do the same procedure on both aileron control horns.
10. Cut a slot at the bottom rear fuselage, install tail
skid in place with CA glue.
11. Drill 5/64”(2mm) pilot holes for mounting the
elevator servo, next connect a 12” extension wire
before you secure the servo in place. Do the same
way on rudder servo.
12. Locate the pushrod and clevis, thread the clevis
at least 6mm then snap onto the FRP control horn,
make sure servo is in neutral position then make
Z-bend and cut the excess pushrod. Insert the
Z-bend end to the servo horn and secure the servo
horn on the servo as shown. Do the same way to
the other pushrod.
5
Rudder
