THUNDER TIGER Raptor 50 V2 kit, Manual

Page: 21 / 42

19
Setting up Main Rotor Blades Pitch Angle
For Beginners
For Intermediates
For F3C or 3D
Top End Pitch 11 û
Hover 5.5 û
Beginners -2 û
Intermediates -5 û
Bottom End Pitch -10 û
Pointer
Throttle Stick in the center
position
Mount the Steel
Linkage Ball at
13~15mm from the
center of the servo
horn.
(Hint for beginners)
The hovering pitch angle should be at 5.5 û . To get the -2 û to
11 û collective range, mount the steel linkage ball at 13~15mm
away from the center of the collective servo horn.
5.5 û
5.5 û hovering pitch angle is used for beginners, intermediates and experts. The throttle/collective must
be in the center position when adjusting the collective pushrod length to make the "point" line up with the
5.5
û hover point on the molded scale (see above diagrams).
On the left side frame, there are
three pitch scales molded onto
the plastic frame. The three
different scales are designed for
beginner, intermediate or expert
F3C and 3D pilots.
Use the "pointer" on the collective
tray and the plastic molded scales
to set up the initial collective
control.
The actual blade angle in degrees
can be checked using a pitch
gauge (sold seperately).
•
•
•