43. Locate the wiper and upper wire strike as well as its
relative hardware.
44. Install the wipers, upper wire strike and antennas
in front of the windshield as photo shown.
46. Assemble the external hoist mount first then secure
the hoist on the mount with the mounting strip and four
2x6mm self-tapping.
48. Trim all windows and both sand the glue area on
windowsand fuselage. Epoxy the windows in place
properly. You mayskip installing the middle window for
engine adjustment and any maintenance of helicopter.
50. Cut the front fuselage then join the front fuselage to
the rear fuselage with 16 pieces of 2x5mm wood screws.
Congratulations! Now you are finished the assembly of
this beautiful scale body.
1.When hovering your 109, try to keep your rotor speed
at approximately 1500 RPM.
2.Check the helicopter and fuselage to see if any screw
loosened after each flight.
3.Trim the elevator or rudder when switching on the idle
when you process the speed flight if necessary.
45. Install the lower antennas as well as the lower wire
strike.
47. Next install the hoist assembly on the fuselage as
photo shown.
49. Install the rotor head back to the helicopter, make
sure all links are well connected and servos work fine.
Template for Tail End Opening
15
14
Summary of Contents for Agusta A109
Page 16: ...MEMO 16...
