12
A
www.chariotcarriers.com 51100967
4.7 InstallInG the handleBar
A.
Position the handlebar behind the carrier with the
handles pointing rearwards. (See image 1)
B.
Release the quick-release levers on the Accessory
Cross Bar.
C.
With one hand on each side of the handlebar, press
and hold the spring buttons in on both ends of the
handlebar. (See image 2)
D.
Slide both ends of the handlebar into the upper frame
of the carrier. Allow the spring pins to pass inside the
upper frame.
E.
Slide the handlebar into the upper frame until the spring
pins engage.
1
2
WARNING
Before each journey make sure that all of the
spring pins in the handlebar are fully engaged.
Any load attached to the handle affects the
stability of the child carrier.
F.
Verify that the handlebar is securely attached to the
carrier by giving it a sharp pull - it should not pull out.
G.
Tighten the quick-release levers on the Accessory
Cross Bar
H.
Repeat this process to install the grips into the handlebar.
I.
To remove the handlebar; Release the quick-release
lever on the Accessory Cross Bar. Press both of the
spring pins through the upper frame and pull the
handlebar out. Repeat this process to remove the grips
from the handlebar.
CX_Manual_English_100412.indd 12
09/01/13 2:35 PM
Summary of Contents for Chariot CX 1
Page 1: ...CX 1 2 USER GUIDE...
