Thrane&Thrane SAILOR 6249, Installation Manual

Page: 27 / 88

Installing the VHF radio
98-133942-
A
Chapter 2: Installation 2-7
In
st
a
ll
a
ti
on
5. Ensure that the flush mount gasket is placed correctly on the VHF radio.
6. Before mounting the VHF radio be aware that the surface is plane and rigid. If the
surface is not plane and/or rigid (stiff) remove the gasket and seal with silicone
sealant between the VHF radio and the surface.
7. Slide the VHF radio in the cut-out. Place the flush mount bracket and fasten it with
the 4 screws M4x45. Make sure the torque does not exceed 1Nm when fastening the
screws.
.
Note
Only use screws supplied with the kit for flush mounting.
Figure 2-7: Flush mount
Note
Firmly tie back and secure any wires not used to avoid the possibility for mutual
shorting or shorting to ground.