Thrane&Thrane Sailor 6081, Installation & User Manual

Page: 17 / 68

Chapter 2: Installation
10 Installing the Power Supply Unit and Charger
Grounding
1. Connect chassis to ship with a cable (minimum wire cross section: 4 mm
2
)
or equivalent. The maximum cable length is 1 m.
2. Connect the drain wire for each cable to the designated GND terminal or
bolt it to the mounting plate as shown below (2.).
3. Ground the Power Supply Unit and Charger to ship, for example at the
screw holding the mounting plate, as shown above (3.).
Connectors and jumpers
• AC input (on SAILOR 6080 Power Supply)
• DC output (50 A) (X10)
• 2 x DC output (20 A) (X11 and X12)
• 2 x DC output (10 A) (X13 and X14)
• 15 V DC output (3 A) (X15)
• Battery connector (X2)
• Battery temperature sensor S1 (X9)
• Ethernet interface for monitoring and control (X6)
• Interface for legacy battery panel and relay output for AC alarm (X5)
• Relay output for battery voltage alarm (X4)
• C1, C2, C3 and C4 for Control data
• P1, P2, P3 and P4 for DC input from SAILOR 6080
• Cross link interface (X8) when sharing a battery
• Jumper J500 for cross link interface (X-LINK POWER)
• Jumper W503 for termination of cross link
(2.)
(3.)