Thrane&Thrane Sailor 6081, Installation & User Manual

Page: 18 / 68

Chapter 2: Installation
Installing the Power Supply Unit and Charger 11
2222
In
st
a
ll
a
ti
on
AC input (on SAILOR 6080 Power Supply)
The SAILOR 6080 Power Supply is AC powered. To connect the AC input do as
follows:
1. Remove the u-shaped cut-out for this input from the protective lid.
2. Connect the Mains cable to the connector marked MAINS AC .
This connector is used when adding a SAILOR 6080 Power Supply (dual row
spring loaded terminal).
Mains AC
Connector type Spring loaded terminal, dual-row connector
Wire cross section Up to 2.5 mm
2
L Line. AC power cord
N Neutral. AC power cord
GND. AC power cord
Fuse 6.3 A. It is accessible from outside the housing. It is
positioned next to the on/off switch.
To remove the fuse turn the device that holds the
fuse and extract it.
AC input
To connect to additional
AC/DC Power Supply