Thrane&Thrane SAILOR 5131A, Technical Manual, Page: 13 / 36

2 Installation Console 5000
2-7
2.3 Mounting the console onto the bulkhead
When the console is placed on a table, the back of the console can be attached onto the bulkhead.
This allows for free access to the connection board and wiring while installing.
1 Remove the rear (back cover) panels, by removing all 6 screws in each panel.
(These will not be needed further and may be discharged of).
2 Remove the edge-profile, from top of the right end of the console (3 screws).
3 Remove the plate on the right end of the console (5 screws).
99 -12 699 4
2
3
1
4 Remove all key-hole screws from the back.
5 Using a hacksaw, cut away the back part, of the bottom plate, by following the pre-cut lines.
Do this on sections, where connection boards are fitted.
99 -12 699 5
*
**
**
*
4
5
9
0815