Switch on the EXPLORER™ 527
Push the power button in the left side of the front panel to switch on the
EXPLORER™ 527.
The display and the green power indicator in the front panel light up when
the EXPLORER™ 527 is on.
Enter the PIN code
a. When you are asked for a PIN code,
press
OK
.
b. Press
or
a number of times
until the first digit is correct.
c. Press
OK
to go to the next digit.
The previous digit is indicated by a *.
d. After pressing OK to enter the last digit, press OK to apply the PIN code.
Connect to the BGAN network
After connecting the antenna to the EXPLORER™ 527 and starting up the
EXPLORER™ 527, the antenna starts searching for a BGAN satellite signal.
When the PIN is entered, the EXPLORER™ 527 attempts to register on the
BGAN network.
The antenna indicator shows the status as follows:
•
Flashing green:
The antenna is searching for the satellite signal.
•
Steady green:
The antenna is registered on the BGAN network and is ready
for use.
•
Red:
Antenna error.
The display shows the progress as follows:
•
SEARCHING:
The EXPLORER™ 527 searches for the network operator. Note
that the search procedure can be very short, so you may not see this text.
7
6
5
32631-exp527-GetStarted-NOILL-PMS 22/06/06 9:23 Side 6
