35
T-Cube Position Aligner
5.2.2
Wiring and Software Settings for Revision 1 Piezo Drivers
The following procedure describes a typical set up, with the TPA101 position aligner
being used with a pair of Rev 1 TPZ001 piezo driver cubes - see Fig. 5.2 for a general
system schematic diagram.
1) Perform the mechanical installation as detailed in Section 3.2. of this manual and
also in the manual supplied with the T-Cube Piezo drivers.
2) Connect the LV OUT XDIFF and LVOUT YDIFF terminals on the rear of the
position aligner to the associated EXT IN terminals on the rear of the Piezo
Drivers.
Fig. 5.2 Typical Set Up - Rev 1 TPZ001 Units
3) Connect the HV OUT terminals on the rear of the Piezo drivers to the associated
piezo actuators.
4) Connect the laser to the laser driver.
5) Install any mechanical components such as turning mirrors etc. which may be
required in the beam path - see Section 4.1. for a typical set up.
PC
HeNe
ASM003
Piezo Mount
KM100
Mirror Mount
POWER
apt
VO LT S
JOG
CONTROL
POWER
apt
VO LT S
JOG
CONTROL
TPZ001
TPZ001
TQD101
PDQ80A QDP Sensor
BP150
Beam
Splitter
CLOSED LOOP
OPEN LOOP
MODE
POWER
DETECTOR IN
SUM
LV OUT
XDIFF
LV OUT
YDIFF
EXT IN
HV OUT
MONITOR
EXT IN
HV OUT
MONITOR
To Piezo Actuators
To Experiment
