ORIC
®
Piezo Stage Controller PDXC
Chapter 5: Software
Rev B, September 23, 2021
Page 35
Figure 5.22 Switch Both Devices to Trigger Mode
Configure device 1 (the top GUI in the example below) to be Fixed Step Size mode, defining the step size (0.5 mm
in the example), while device 2 (the bottom GUI in the example bellow) to be Fixed Positions mode
,
defining the
two positions with their own edge type (-5 mm in rising edge for Pos1 and 5 mm in rising edge for Pos2 in this
example).
With all these settings done, press the Move or Jog Step button in closed-loop operation, which will start this Scan
motion. The operation will run until one device runs out of range; it will stop automatically. During this scan, you
can see Device 1 move at step distance each time Device 2 finishes a motion back and forth.
