Red HeNe Laser System
12112-S01 Rev CB, August 31, 2010
Page 13
www.thorlabs.com
Part 5. Operation
To operate the laser system, follow the following procedures.
1)
Make sure the laser is pointing safely away from people and is securely mounted.
2)
Turn the key safety switch on the back of the unit. NOTE: There is a 3 to 5 second CDRH safety
delay before the voltage turns on.
Figure 8 Laser Rear Panel
3)
Open the aperture by sliding the lever left so the ON label is visible.
Figure 9 Laser Shutter Control, Picture shows the Shutter CLOSED.
3-Port, High-Power Connector
Power On/Off Key
Power ON/OFF safety key.
Lever Slides
Off
On
Power Mains
Phono Plug
Power On LED
Lights when key switch is
turned, not when laser is lasing.
Interlock Connector
Make sure the interlock is
connected and fully seated.
Fuses
