Cerna Mini Microscopes
Chapter 4: Getting Started
Page 12
TTN109666-D02
4.3.2
Fluorescence Filter Installation
The SFMGFP and SFMGFP2 each ship with an MDF-GFP filter.
Note:
The
SFM module does not come with a filter cube nor a filter set. Use filter
cube item # MDFM-MF2 to install your filter set in the Filter Cube Housing.
To install the MDF-GFP filter:
Figure 8
Replacing the Filter Set
1. Use a 1.5 mm hex key to remove the screws (2X) from either side of the
Filter Cube Housing cover.
2. Use a 2.5 mm hex key to loosen the screw at the center of the cover to
slide out the filter cube.
3. Install your filter set inside the filter cube. See the MDFM-MF2 manual for
detailed instructions-
https://www.thorlabs.com/manuals.cfm
4. Slide the filter cube on the Filter Cube Housing cover and tighten the
screw at the center of the cover
.
2X M2 x 5 mm
Screws
M3 x 10 mm
Screw
Summary of Contents for Cerna Series
Page 1: ...Cerna Mini Microscopes User Guide...
Page 41: ...www thorlabs com...