November 30th 2018
www.thonk.co.uk
12
God’s Box Lollipop
Eurorack DIY Kit
Instructions
Version 1
24.
Now switch to the top board and
place but DO NOT SOLDER the 2x5
and 2x8 (or two 1x8) female headers
onto the top board. The female
headers sit on the opposite side to all
other components.
Before soldering these headers –
connect them to the male headers on
the bottom PCB. Once you have the
PCBs connected nicely with the
headers sitting flush you can then
solder them in place.
Now is also a good time to screw the
spacers onto the top board.
SWITCH TO OTHER PCB!
Top Board
25.
Now disconnect the PCBs and place
but DO NOT SOLDER the pots,
jacks, LED bar and switch.
Be sure to match the pot values to
the PCB silkscreen as shown. Screw
just one of the nuts onto the switch
- do not use the switch washer.
26.
NOTE!
Orientation matters for the
LED bar
. One of the corners is
flattened - make sure you align this
with the PCB silkscreen. Now you
can carefully place on the front panel
and screw the nuts and washers onto
the pots, jacks and switch.
NOTE:
Read the next step before
soldering the LED bar
B100K
B10K
B10K
A10K
Flat Edge
Flat Edge on
Silkscreen
