16
EN
15
16
TIME SETTING
In standby mode:
• Press and hold
PROG/MEM/C-ADJ
.
• Press
7
or
8
to switch to 24H or 12H mode.
• Press again
PROG/MEM/C-ADJ
to validate: The time
display flashes.
• Set the time with
7
or
8
.
• Press
PROG/MEM/C-ADJ
to validate, the minutes
display flashes.
PROGRAMMING THE TURNING ON /OFF OF THE DEVICE
In standby mode:
• Press and hold
TIMER
: the symbol “
ON
” comes up
on the VFD screen and the time display flashes.
• Press
7
or
8
to set the time, then
TIMER
to confirm
and then set the minutes.
• The symbol “
OFF
” comes up. Set the time of the
shut down.
Note
: Use the same setting process as the one for
turning on.
• Press
TIMER
again: “CD” comes up on the screen.
• Press
7
or
8
to select the desired mode when
powering up: TUNER, iPod, CD or BUZZER.
• Press
TIMER
again to set the volume, except if you
select the BUZZER mode.
• Press
7
or
8
to set the volume, then
TIMER
to
confirm.
• Press
TIMER
again, the information that you have just
defined appear on the VFD screen.
• Press
TIMER
to cancel the programming:
the «
»
signal disappears.
USING THE CD PLAYER
Note
: Before using the appliance for the first time, remove
the cardboard protecting the lens located inside the CD
compartment (
13
).
Playing a CD:
• Press
FUNCTION
to select the «CD» mode.
• Set the volume with
VOL+/ VOL-
.
• Open the CD compartment by pressing then insert a
CD (label side towards you).
• Close the CD compartment by pressing again .
Selection of the tracks:
• Press
7
or
8
to go to the previous or next track. The
track number will appear on the screen.
• Press and hold
7
or
8
to go fast forwards or
backwards. Disk playback resumes when you release
the keys.
Pause and playback mode
• Press
12
to pause the player. Press again to resume
playback.
INSTALLATION (See pictures below)
The device can be installed:
• Either on a stand (
15
), put the hooks from the base in
the central cavity at the back of the device. Check that
the base does not come off. To remove the base, pull it
downwards.
Mains power supply
• Connect the cable socket to the plug (
17
).
• Connect the other end of this cable to a socket.
• Press
q
to switch on the device.
Note
: To use each function of the device, make sure it is
running.
• Either the wall using 2 screws and 2 plugs (supplied)
attached so there have about 6.5 mm gap between the
screw heads and the wall. Hang the unit by two holes
(
16
) on the back.
USING
WALL MOUNT MICRO SYSTEM
WM40i
