Chapter 1: Connections and Setup
Illustrations contained in this document are for representation only.
5
Chapter 1: Connections and Setup
Turning on the Wireless Voice Gateway
If there is no lighted LEDs on the front panel, check the power on/off switch position on the back panel
of Wireless Gateway: it must be ”ON” = “1”.
After installing the Wireless Voice Gateway and turn it on for the first time (and each time the modem is
reconnected to the power), it goes through several steps before it can be used. Each of these steps is
represented by a different pattern of flashing lights on the front of the modem.
Note: All indicators flash once before the initialization sequence.
If both DS and US LEDs are flashing, it means the Wireless Voice Gateway is automatically updating its
system software. Please wait for the lights to stop flashing. Do not remove the power supply, switch off
(on/off switch) or reset the Wireless Voice Gateway during this process.
Introduction
Wireless Voice Gateway Features
•
High Speed Data Service Solution
•
EuroDOCSIS 3.0 cable modem, dual-mode (DOCSIS / EuroDOCSIS)
•
Giga Ethernet router with 4x Standard RJ-45 connectors for 10/100/1000Mbps. Auto-negotiation
and MDIS functions
•
Wi-Fi 11n wireless connection
•
Wireless security: multiple SSID and WPS solution
•
Two RJ-11 Foreign Exchange Station (FXS) ports for phone and fax connections
•
Support simultaneous voice and data communications
•
Two simultaneous voice conversations in the different FXS ports with different CODEC: PCM
A-law, PCM-law, G.723.1, G.729, G.729a, G.729e, G.728, G.726, BV16 and BV32
•
Echo Cancellation
•
Voice Active Detection (VAD)
•
DTMF detection and generation
•
Comfort Noise Generation (CNG)
•
Support V.90 fax and modem services
•
RSA and 56 bit DES data encryption security
