4
MENU
Represents a button on the remote control or the receiver.
(Bold characters)
Move
to
Represents a menu item within a screen.
(
Italic
characters
1.4 Accessories
-
1x Installation instructions
-
1x remote control unit
-
2x batteries (AAA type)
-
1x adapter12 Volt DC, 1,5 Ampère
1.5 Usage of external USB devices
-
It is recommended to use USB 2.0 or higher storage devices. If your device is not compatible to USB
2.0 specifications, recording, Time shift and playback with your receiver might not work properly.
-
If you are going to use external USB HDD (Hard Disk Drive) please consider that it might be the case
that the power specifications exceed the supported output of your receiver (5 V/1 A). If so, please
connect your USB HDD to an according external power adapter.
-
STRONG cannot guarantee compatibility with all types of USB storage devices.
-
It is advised not to store important information on USB storage devices used with the receiver.
Always make backups of data on your USB storage device before using it with this receiver. STRONG
will not take responsibility for any loss of information or circumstances caused by loss of information.
-
Please ensure that either the USB device is already formatted to FAT32, or format the USB device via
your receiver, refer to chapter
6.8 Recording
.
-
Playback of files cannot be guaranteed although extensions are listed, as it depends on codec, data
bit rate and resolution used (all MPEG codec formats are supported).
2.0 YOUR RECEIVER
2.1 DEFAULT PIN-CODE: 0000
2.2 Front Panel
Obr. 1a
1.
q
Switches the receiver ON or into Standby
2.
P-/P+
Changes to the next/previous channel
3.
Indicator LED
GREEN indicates that the receiver is currently ON,
RED indicates that the receiver is currently in standby mode.
4.
USB
To connect your USB storage device
2.3 Side Panel
Obr. 1b
1.
Smartcard slot
To insert your valid and activated Irdeto smartcard for proper
reception of your desired channel bouquet. For the correct insertion
of smartcard please see the insertion drawing.
2.4 Rear Panel
Obr. 2
1.
SAT IN
To connect to the LNB of your satellite antenna for reception of
satellite broadcast signal
2.
IR
To connect the IR extender
3.
S/PDIF (coax.)
To connect to a digital amplifier or home theatre set
4.
HDMI
To connect to the HDMI input of your TV set using a good quality
HDMI cable
5.
TV SCART
To connect to your TV set using a SCART cable
6.
Power adapter
To connect to the original included main power adapter
(Input 110 ~240V 50~60 Hz/ Output 12 V DC/ 1,5 A
)