P6
ConnECTIons
28.
goTo
In playback mode: opens the time banner for
selecting the moment where to jump to
29.
P+/-
Switches to the previous/next programme in
TV mode
30.
dTv/vCr
Switches to VCR input if the receiver is in DTV
state. Switches to DTV if it is in VCR state
31.
0-9
Channel number and numeric value input
32.
Tv/radIo
Toggles between TV and radio mode
2.5Installingthebatteries
Fig. 4
Remove the battery cover from the remote control and put 2x AAA size batteries
inside the compartment.
The diagram inside the battery compartment shows the correct way to install
the batteries.
1. Open the cover
2. Install batteries
3. Close the cover
noTE:
The batteries should not be recharged, disassembled, electrically
short-circuited, be mixed or used with other types of batteries.
2.6usingtheremotecontrol
Fig. 5
To use the remote control, point it towards the front of the digital receiver. The
remote control has a range of up to 7 metres from the receiver, if properly aligned
towards the IR eye on the front panel.
The remote control will not operate if its path is blocked.
noTE:
Sunlight or very bright light (such as TL lighting) might decrease the
sensitivity of the remote control.
3.0ConnECTIons
3.1basicconnectionusingascartcable
Fig. 6
a. Connect the LNB of your satellite antenna to the SAT IN connector of your
receiver using a good quality coax cable and suitable ‘F-connector’ plugs.
b. Connect one end of a good quality Scart cable to the TV SCART connector on
your receiver and the other end to the SCART input of your TV.
c. Plug the power cord to a suitable wall outlet.
3.2basicconnectionusinganhdmIcable
Fig. 7