1.Place the product in an upright position on a flat, steady, stable, heat-resistant
surface. (Casters on the floor) Make sure there is nothing flammable or heat sensitive
within 1 meter. Operating the product in any other position could cause a hazard.
2. Insert the mains plug into a suitable wall socket, a bip sounds and icon
light on.
Always ensure the powercord is fully unwound and doesn’t touch the product in use.
3. Press the power button ( ) once to start the heater on High Power, the unit will run on
High Power
4. Press the power button MODE to select the high power / Mid power / low power /
eco.
High power
Mid power
Low power
In Eco mode (
): press
/
to set the required temperature. When the ambient
temperature is much lower than the set temperature, the product is heated at a high
power; when the ambient temperature is close to the set temperature, the product is
heated at a low power. When the ambient temperature is higher than the set
temperature, the product stops heating.
5. Press the power button ( ) again to turn the heater in Standby.
ADJUST TEMPERATURE
1. Use the buttons
" " and " "
to set the desired temperature.
2. The temperature icon will stop blinking and the target is set.
3.
The icon thermostat
light on when the heating element is working
4.
The heater stops to heat when the ambient
temperature reached the desired
temperature.
5. The heater will turn back on when the room temperature drops below the desired
temperature.
Note: By default, the pre-registered temperature at factory is 35°C and mode high
power.
TIMER (AUTO-OFF)
This function should only be set if you desire that the heater be automatically shut off
after a certain period of time (1 to 24 hours from the time the function is set)
NOTE: Always set the desired temperature prior setting the Timer.
Press the Timer button
until the timer icon blinks.
Use the
" " and " "
button to set the heater operation time between 1 and 24
hours. This function will activate once the timer icon stops blinking. The heater will
automatically turn-off when time runs out.
TIMER (AUTO-ON)
This function provides a delayed start option and should only be set if you desire that
the heater be automatically turned ON after a certain period of time (1 to 24 hours from
the time the function is set).
NOTE: Always set the desired temperature prior to setting the timer so that the heater will
turn on at the desired temperature setting.
GB-9
