THOMSON TG782, Setup And User Manual

Page: 15 / 90

E-DOC-CTC-20090619-0001 v1.0 9
1 Installation
1.2.2 Manual Installation
Requirements
JavaScript must be enabled (this is the default setting) on your browser. For more information, consult the
help of your web browser.
Procedure
Proceed as follows:
1 Connect the Thomson Gateway to your broadband service .
2 Power on the Thomson Gateway .
3 Connect your computer to the Thomson Gateway .
4 Configure the Thomson Gateway .
This is described in the sections below.
Connect the Thomson Gateway to your broadband service
Proceed as follows:
1 Take the DSL cable with the grey connectors. This cable is included in your box.
2 Plug one end of the cable in the grey DSL port on the back of your Thomson Gateway.
3 If you are:
Using a splitter, plug the other end of the cable into the Modem/ADSL out put of your splitter.
Not using a splitter, plug the other end of the cable directly in the wall outlet.
For more information about splitters, see “Filters and splitters” on page 4 .
Power on the Thomson Gateway
Proceed as follows:
1 Connect the power cord to the Thomson Gateway’s power port.
2 Plug the other end into an electrical outlet.
3 Push the power button to turn on the Thomson Gateway.
4 Wait two minutes to allow the Thomson Gateway to complete the start up phase.
Connect your computer to the Thomson Gateway
Setting up a wireless connections
For more information on how to setup a wireless connection to your Thomson Gateway, see “3 Wireless
Access” on page 23 .
Setting up a wired connection
For more information on how to setup a wired connection (i.e. an Ethernet connection) to your Thomson
Gateway, see
“1.4 Connecting a Computer Using the Ethernet Cable” on page 12 .