THOMSON SpeedTouch 180, Manual

Page: 27 / 64

W
IRELESS
3-11
The SSID should be set to the same value as other wireless devices on your
network. It is case-sensitive and can consist of up to 32 alphanumeric
characters. The access point can be configured for roaming clients by
setting the service set identifier (SSID), wireless channel, and other
advanced options.
The wireless settings are listed in the table below.
Parameter Description
Enable Wireless
Networking
Enables/disables wireless networking.
Channel The radio channel used for the SpeedTouch 180 to
communicate with the wireless clients. The SpeedTouch
180 will automatically assign itself a radio channel, or you
may select one manually.
The available channel settings are limited by local
regulations.
SSID The Service Set ID. This should be set to the same value as
other wireless devices on your network.
The SSID is case sensitive and can consist of up to 32
alphanumeric characters.
SSID broadcast Allows the user to show/hide the SSID. (Default: Enabled)
Transmit Rate The transmit rate is automatically adjusted based on the
receiving data error rate. Usually the connection quality will
vary depending on the distance between the wireless router
and wireless clients. You can also select a lower
transmission rate to maximize the radio communication
range. (Default: Automatic)
Turbo mode Enables/disables turbo mode. The turbo mode
implemented with the Wireless Access Point can
dramatically boost your wireless connectivity with speeds of
up to 108 Mbps.(Default: Enabled)
Wireless mode Select the type of wireless network. The SpeedTouch 180
can support a mixed mode of 11b and 11g, 11g only, and
11g Turbo.