THOMSON SB220B, Manual

Page: 17 / 76

15
SETTING UP THE DEVICE
INTRODUCTION
INSTALLATION
The SB220B THOMSON sound bar enables to:
• Play sound from an audio source (iPhone/iPod, DVD/Blu-ray player, video game
console, etc).
• Play music through a Bluetooth enabled device.
• Place the device on a flat, rigid and stable surface. Leave at least 10 cm of space
behind, above and either side of the device to avoid obstructing the air vents or
distorting the sound quality.
• Connect the power plug to a wall socket.
• Press
q
to turn on the device.
NOTE : If not any audio signal inputs to the unit in about 60 minutes, the unit will enter to
standby mode automatically (except at radio mode).
Caution :
• Risk of damaging the product! Make sure the supply voltage matches the voltage
marked on the device.
• Before plugging the power supply cable, make sure all cables are properly
connected.
Connect the power supply cable to the wall socket.
On/Standby
Press
q
to start or suspend the device.
Note :
• When the device is, activated, it starts in the same mode selected for the last
playback.
• Disconnect the mains cable from the socket when the system will not be used for
a long time.
• In stand-by mode, press and hold CLOCK on the remote control: the hour display
flashes.
• Adjust the hour using TUNE (
7
/
8
) on the remote control.
• Press CLOCK , the minute display flashes.
• Adjust minutes using TUNE (
7
/
8
)
• Press CLOCK to confirm.
Note : During playback, press CLOCK to display the current time, the press CLOCK
again to go back to previous display.
MAINS POWER SUPPLY
SETTING THE TIME
EN
BLUETOOTH
®
SOUNDBAR
SB220B
Downloaded From Disc-Player.com Thomson Manuals